I have provided this information because of Customer requests

I do not however recommend this TEST, it is a dangerous

procedure that can cause serious bodily injury if not done correctly

So please proceed with extreme

!CAUTION!

 

Do NOT use a Battery charger in place of a Battery!

A good Quality set of jumper cables are required as well!

 

1^st: Connect a set of jumper cables as per diagram

����� You will need a jumper wire (I Recommend 10 Gauge)

����� as illustrated by yellow wire with alligator clips in drawing

2^nd: Connect one end of the 10/GA wire to the Pos Post of

����� the Starter. (Caution) (Keep hands & clothing clear of

����� the Gear) It is very important to have a good hold on the

���� �Starter, because when it begins to run there will be a jerk

���� �from the tork it creates. Now touch the other end of the

����� 10/GA wire to the spade (or) on some Starters it will be a

���� �small silver post.

����� If the Starter works, you will here a snap, this is the Plunger

����� traveling down to the contacts, and pushing the Starter

����� Drive Gear out, the Starter Motor will begin to run

���� �and the Gear that is now out almost 2 inch�s

���� �will rotate very fast. �